Bones Bearing Cleaning Unit which can be used to clean bearings for skateboards, inline skates and quads but eight bearings at a time. Please note this is a cleaning unit and does not contain any cleaning liquid.

For full steps on cleaning bearings check out our how to guide, here is where the Bones cleaning kit comes in.

• Take your bearings and place them on the axle (metal rod on the lid) alternating from one bearing to one spacer till all 8 bearings are on the axle. For best results make sure that the ball side of the bearing is facing upwards. Fasten them down finger tight onto the axle using the wing nut.
• Fill the bearing-cleaning unit up about 1/3rd of the way full with your cleaning solution and seal the cap. Agitate the cleaning solution by shaking the bottle. Shake for about 30 seconds, open the lid and give the bearings a spin to free up any debris and recap the bottle. Shake until you are satisfied that your bearings are cleaned completely. To make sure they are clean, spin the bearings on the axle.

• Made of fluorinated high density polyethylene
• 7 spacers for a good flush in less time
• Cleans up to 8 bearings at a time
• Cleans all skate bearings
• Cleaning solvents not included

A detailed instruction sheet will also be included with the unit to insure easy and proper use